Denon AVR-1312 - Manual (Page 24)

21
Multi channel stereo playback
This mode is for enjoying stereo sound from all speakers.
1 Playing the source ( v page 12
– 17 ).
2
Press SURROUND 0 or
SURROUND 1 to select “MULTI
CH STEREO”.
Multi channel stereo playback begins.
NOTE
When the input signal is Dolby TrueHD, Dolby Digital Plus, DTS-HD or
DTS Express, you cannot select multi channel stereo mode.
Virtual playback
This mode is for enjoying surround effects using only the front
speakers or headphones.
1
Playing the source ( v page 12
– 17 ).
2
Press SURROUND 0 or
SURROUND 1 to select
“VIRTUAL”.
Virtual playback begins.
NOTE
When the input signal is Dolby TrueHD, Dolby Digital Plus, DTS-HD or
DTS Express, you cannot select virtual mode.
GViews on the displayH
q w
q Shows a decoder to be used.
• A DOLBY DIGITAL decoder is displayed as “DOLBY D”.
• A DOLBY DIGITAL Plus decoder is displayed as “DOLBY DIGITAL
+”.
w Shows a decoder that creates sound output from the surround
back speakers.
For an input signal that can be reproduced in each surround mode, see
“Surround modes and surround parameters” (
vpage 48 ).
Standard playback Stereo playback
This is the mode for playing in stereo. The tone can be adjusted.
• Sound is output from the front left and right speakers and subwoofer.
• If multichannel signals are input, they are mixed down to 2-channel
audio and are played.
1 Playing the source ( v page 12
– 17 ).
2
Press SURROUND 0 or
SURROUND 1 to select
“STEREO”.
Stereo playback begins.
Direct playback
Sound recorded in source is played as is.
• Surround back signals are not created.
• In this mode, the following items cannot be adjusted.
• Tone ( vpage 38 ) • RESTORER ( vpage 39 )
1
Playing the source ( v page 12
– 17 ).
2
Press SURROUND 0 or
SURROUND 1 to select
“DIRECT”.
Direct playback begins.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Basic v
ersion