Rena EasyFeed 120 - Manual (Page 12)

EasyFeed_120_Operations_
4-25-14
12
STEP 2. Start the feeder and set speed control to a moderate speed.
Caution! When performing these procedures please be sure to keep all body parts and loose
items (clothing, hair, necklaces, etc..) away from the moving parts of the feeder.
NOTE: If the feeder interlock won’t allow you to run the feeder to perform this task, flip the
“Stand Alone” switch to the opposite position so that the feeder will run without the interlock.
Please be sure to return this switch to the correct position after performing this task.
STEP 3. Raise each separator a bit so that the belts do not rub on them as you
reposition each belt.
STEP 4. Loosen the locking levers on the belt guides and SLOWLY slide the belts you
intend to use toward the middle of the feeder.
Speed control
Turn knob clockwise
to raise separator
Raise separator high
enough so it doesn’t
rub belts.
Power
With feeder running, loosen knob
and move belt guide block by
pressing against the block.
DO NOT TOUCH MOVING BELTS!