Rena Envelope Imager 3.0 - Manual (Page 20)

SECTION 2
PRINTER INSTALLATION & SETUP
Print Unit Positioning (Vertical Address Positioning)
The print units are the device that contains the pen stalls and inkjet cartridges. To adjust the vertical
position of the address (printed image) on the media, you must move the Print Units to the desired print
positions.
1. Loosen the Print Unit Securing Knobs. See Figure 25 .
2. Slide the Print Units to the desired positions as shown in Figure 25 .
3. Tighten the Print Unit Securing Knobs.
4. Reposition the Exit Rollers, so they make contact with the media, but do not track over the image
area, as shown in Figure 26 .
5. Envelope Imager 3.0 Only. Reposition the Paper Transport Guide so that it helps hold down the
media before it enters under cartridges 4, 5 and 6, as shown in Figure 27 .
Note: Horizontal print position is adjusted via your software (mailing program).
Figure 26
Figure 25
Figure 27
20
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007