Remotec BXT-120 V2.0 - Manual (Page 26)

26
12
Place the BXT‐120 and your device
remote as shown, aimed at each
other 1‐3 inches apart.
Click “Start” to enable the learning.
LED stay off
13
Press and keep holding the key on
your original equipment remote
which you want to learn until LED
flash and prompt on the screen the
learning result, it may take few
seconds or more depending on IR
codes of your remote. => LED flashes
twice if the
command has
been learned
successfully
=> LED flashes 6
times, it shows an
error in the
learning process
(Adjust the
position of your
remote and
repeat from step
12 again)