REMKO Elektric Booster Heater with Emergency Heating Switch - Manual (Page 7)

7
! ATTENTION
Connect the earth conductor!
11. Screw in the electric heating coil
(Fig. 3+4).
12. Shut-off valves must be opened
again.
13. Fill up the water side and
bleed the system.
14. Perform leak testing on the system.
15. Insert the cables into the electrical
switch cabinet.
! ATTENTION
All electrical installation work
is to be performed by specialist
companies. Disconnect the voltage
supply when connecting the
electrical terminals.
4 Screwing in the electric heating coil
Electrical connection
1. Install contactors K6 and K8
as well as the additional terminals
(see Figure 5+6)
5 Installing the contactors
6 Installing the additional terminals