Remko, Way switching valve dn 40, Manual mode – REMKO DN 40 User Manual

Page 8

Text mode
Original mode

REMKO

3-WAY SWITCHING VALVE DN 40

Manual mode

The 3-way switching valve can
be operated manually until the time
of commissioning or in case of a defect
of the actuator. The electrical actuator
must be removed in this case.

CAUTION

The replacement of the actuator
must take place in a de-energised
(electrical) state. Also disconnect
the main connection to the actuator.

To do so, proceed as follows:

1. Loosen the union nuts of the

actuator. These can be found under
the white actuator. Then you can
simply remove the actuator.

2. Screw on the delivered plastic cap

in the appropriate position, to set the
desired position.