REMKO RXS xxx H - Manual (Page 5)

The equipment is shipped in sturdy
transport packaging. Immediately
check the equipment on delivery
and make a note of any damage or
missing parts on the delivery note.
Inform the forwarding agent and
contractual partner.
Warranty claims at a later date will
not be accepted.
The outdoor component of
split-design combined room air
conditioning units serves to output
the heat extracted by the interior
unit from the room being cooled.
If combined heating/cooling
units are operated as heaters, the
heat absorbed by the outdoor
component can be discharged
by the interior unit into the room
being heated.
The unit can be installed outdoors
or indoors. The latter requires the
fulfilment of certain conditions.
Description of the
equipment
Transport and
packaging
The connection between the indoor unit and the outdoor component is
made with refrigerant pipes.
Suction pipe
Outdoor
component
System design
Injection pipe
Indoor unit
Indoor area
Outdoor area
Stop valve
Liquefier fan
Condensation pipe
Condensation pipe
Control cable
Mains cable
M
M
Schematic of refrigerant circuit
Liquefier fan
Connection valve
Suction pipe
Connection valve
Injection pipe
Compressor
Capillary tube flow regulator Filter dryer Liquefier
Reverse flow valve
Connection
Manometer
Intended use
Depending on the model, the
equipment and the additional
fittings with which it is equipped
is only intended to be used as an
air-conditioner for the purpose of
cooling or heating the air in an
enclosed room.
Different or additional use shall not
be classed as intended use. The
manufacturer/supplier assumes no
liability for damages arising from an
unintended use of the equipment.
The user bears the sole risk in such
cases.
Using the equipment as intended
also includes working in accord-
ance with the operating manual
and installation instructions and
complying with the maintenance
requirements.
The outdoor component comprises
a refrigerant and compressor,
Finned liquefier, liquefier fan,
reverse flow valve and flow
regulator.
The outdoor component can be
combined with REMKO indoor
units that provide sufficient cooling output (see table
"Combinations"). The outdoor
component is controlled via the
regulation of the indoor unit.
Winter controllers, floor brackets,
wall brackets and refrigerant pipes
are available as accessories.
5