REMKO RM Series - Manual (Page 9)

A flashing dot on the remote control indicates that the remote control is
ready for operation. Remote control ready for operation
RESET B utton Pressing the RESET button in the battery compartment resets the remote
control. The current time then has to be reprogrammed (see "CLOCK
button“).
RESET 5 sec. Setting the clock
Press the CLOCK button in the battery compartment to set the time.
"CLOCK" will flash on the display. The HR. and MIN. buttons are used
to set the current time. Press the CLOCK button again to complete the
programming procedure, the display will stop flashing.
CLOCK B utton
CLOCK HR/MIN CLOCK
Press the ON / OFF button to activate or deactivate the air conditioning
unit. The programmed settings and parameters are shown on the display
before the unit switches off.
ON/OFF B utton
ON/OFF ON/OFF
A symbol is shown on the display to indicate that the settings are being transferred.
Button functions
9