REMKO RM Series - Manual (Page 8)

"TIMER OFF" Button
Press this button to set an
automatic equipment switch-off
time in the next 24 hours.
"HR" Button
Press this button to set the
hours.
"MIN " Button
Press this button to set the
minutes.
"RESET button"
(in battery compartment)
Press this button to reset the
remote control to its factory
default configuration.
"CLOCK" Button
(in battery compartment)
Press this button to activate
clock setting mode.
"DISPLAY" Button
Press this button to switch the
display on and off (does not
affect the function of the
equipment).
B uttons on the remote control 2. Cooling mode
In this mode the warm room
air is cooled to the desired
temperature.
3. Dehumidifying mode
In this mode the room is
mainly dehumidified, the set
temperature is maintained.
4. Heating mode
Heating mode is not supported.
"FAN" Button
Press this button to set the
required fan speed. 4 levels
are available: Automatic, high,
medium and low fan speed.
"FINS" Button
Press this button to adjust
the position of the outlet
fins. 5 fixed positions and
an oscillating function are
available.
"SLEEP " Button
Pressing this button
will automatically increase or
decrease the target temperature
by 1 °C every hour in cooling
and heating mode respectively.
"SWING" Button
This button activates the
oscillating fin function
to provide improved air
distribution in the room.
"TIMER ON" Button
Press this button to set an
automatic equipment switch-on
time in the next 24 hours.
Buttons on the remote control
"ON/OFF" Button
Press this button to start the
equipment.
"TOO HOT" Button
Press this button to reduce the
desired temperature
to a value as low as 16 °C.
"TOO COLD " Button
Press this button to increase
the desired temperature
to a value as high as 31 °C.
"MODE" Button
Press this button to select the
operating mode. The indoor unit
has 4 modes:
1. Automatic mode
In this mode the equipment can
be running in cooling or heating
mode.
REMKO RM
8