REMKO RM Series - Manual (Page 10)

▲/▼
Buttons
The ▼ button is used to reduce the target temperature, the ▲ button
increases it. In automatic mode the temperature can be increased
or decreased by 1°C. Temperature adjustment is not possible in
dehumidifying mode.
Cooling mode
The display extinguishes
after 1 min.
Automatic mode
MODE Button
Press the MODE button to switch between the operating modes. A total
of 4 modes are available:
1. Automatic Cooling or heating mode (not supported)
2. Cooling Mainly used in summer
3. Dehumidify Used in summer or winter
4. Heating mode not supported
MODE MODE MODE
Automatic Cooling Dehumidify Heating (not supported)
In automatic mode, the controller automatically selects heating or cooling
mode after it is switched on. The control range is 22 °C to 26 °C. This
can be raised or lowered using the
▲/▼ buttons.
AUTOMATIC Mode
AUTOMATIC
MODE
In cooling mode the room air is cooled to the preset target temperature.
The desired room temperature is set in 1 °C steps using the
▲/▼ buttons.
If the room temperature reaches 0.5 °C above the set target temperature,
the indoor unit starts to cool the room air. If the actual temperature falls
approx. 1 °C below the set room temperature, the controller switches the
cooling off. In order to protect the compressor, the controller will only
switch the cooling back on after a holding period of 3 minutes.
COOLING Mode
COOLING
MODE
MODE
▼ ▲
▼ ▲
REMKO RM
10