REMKO MKT 290 - Manual (Page 8)

During cooling mode, the unit ge-
nerates warm air. This air must be
expelled from the room to retain
the cooling effect.
It is therefore necessary to insert
the supplied exhaust hose into the
air outlet opening at the back of
the unit.
Different ways of expelling air
You can expel air from the building
as follows:
With a flat nozzle.
The flat nozzle supplied can be
used in different ways. It is possible
to guide the flat nozzle through
the open window and se cure it
firmly using straps and suction
devices. (Fig. 1, page 9).
The flat nozzle can also be hung
through the partially opened win-
dow (Fig. 2, page 9).
From the back of the device to
the back of the wall must be
a minimum distance of about
20 cm.
Bevore Commissioning
The device is placed at the desired
location, with the outlet side to the
room. Note the list the following
information.
■ Allow the device to the box
at least 5 minutes stand on its
transport wheels before opera-
ting it.
■ Place the unit stable on a flat,
stable surface. Uneven floors
can cause
vibration and
unwanted
noise.
■ All extensions
of the power
line must have
a correct cross
section and may be used only
fully rolled out.
■ Never operate
the unit with-
out the intake
filter. Without
an air intake
filter, the plate
fins of the eva-
porators be-
come dirty and
the unit’s performance is adver-
sely affected.
■ Make sure that
people and
objects, such
as plants in the
room, are not
directly in the
path of the
expelled air.
Condensa-
tions drain
with plug
In case of direct sunlight, make
sure to close all curtains and
blinds.
Keep doors and windows clo-
sed during operation.
TIP
Circulation filter
■ Check that
the plug-in of
condensation
drain placed
available and
that is correct.
There is a
risk of un-
controlled condensate outlet is
after commissioning.
Expelling the warm air
CAUTION !
The exhaust hose is always
embarrassed with a pitch in air
direction and should not be
extended!
CAUTION
!
■ Make sure that the deflector
piece from the top slides down
into the notches on the side
until it clicks into places .
To ensure that the unit operates
effectively, do not place the
flexible exhaust hose supplied
at sharp angles and make sure
there are no
kinks.
■ The air
expelled
from the unit
contains a
certain amount of moisture. We
therefore recommend expelling
the air to the surroundings or
the outside.
REMKO MKT
8