REMKO MKT 290 - Manual (Page 7)

„Cool“ mode
1. Attach the air outlet hose to
the wall bushing or the win-
dow.
2. Activate the device using the
“Power“ button
3. Press the “Mode“ button
until the “Cool“ LED lights
up.
4. Select the fan setting using
the “Fan Speed“ button :
“High“ highest speed
“Med“ medium speed
“Low“ lowest speed
5. If the “Room Temp.“ LED
lights up, the current room
temperature is shown in the
display
6. As soon as the / / button
is pressed, the display switch-
es from the room tempera-
ture to the set temperature
(LED lights up) and shows
the desired temperature for
15 seconds.
7. Set the desired room tem- Set the desired room tem-
perature using the “Timer/
Temp. Adjust“ button /
The up arrow increases the
set value shown in the display
while the down arrow
decreases it.
„Dehumidify“ mode
1. Attach the air outlet hose to the
wall bushing or the window.
2. Activate the device using the
“Power“ button .
3. Press the “Mode“ button
until the “Dehumidify“ LED
lights up; the fan is automati-
cally switched to the “Med“ or
medium fan speed stage.
„Fan“ mode
1. Activate the device using the
“Power“ button .
2. Press the “Mode“ button
until the “Fan“ LED lights
up.
3. Select the fan setting using the
“Fan Speed“ button :
“High“ highest speed
“Med“ medium speed
“Low“ lowest speed
4. The room temperature is not in- The room temperature is not in-
fluenced and remains constant.
For this reason, the tempera-
ture and time setting “Timer/
Temp. Adjust“ buttons /
cannot be used.
„Timer“ time delay
You can turn the device on and off
automatically using the timer. To
do so, an activation/deactivation
delay is programmed.
Automatic activation
1. Activate the device using the
“Power“ button .
2. Select the mode and make all
settings for the desired mode.
3. Deactivate the device using the
“Power“ button .
4. Press the “Timer“ button .
5. Set the time using the “Timer/
Temp. Adjust“ button /
Only whole hours can be en-
tered.
6. The LED flashes.
7. The device activates automati- The device activates automati-
cally at the set time.
Automatic deactivation
1. The device is running in the
previously set mode.
2. Press the “Timer“ button .
3. Set the remaining run time us- Set the remaining run time us-
ing the “Timer/Temp. Adjust“
button / . Only whole hours
can be entered.
4. The LED fleshes.
5. The device deactivates auto- The device deactivates auto-
matically at the set time.
You can achieve a pleasant
room climate by selecting a set
temperature that is a maxi-
mum of 4 to 7°C below the
outdoor temperature.
TIP
7