REMKO MKT 290 - Manual (Page 6)

Legend
ON / OFF „Power“ button
„Mode“ button
„Fan Speed“ button
„Timer“ button
+ Temperature/time setting
buttons
„Timer/Temp Adjust“:
higher, lower
Display
Red fault LED:
Reservoir full
An acoustic and an optical
signal indicate that the float
switch of the internal reservoir
has shut down the operation of
the device.
The acoustic signal dies down
after a short period of time, but
the LED remains active.
Mode LED display
Green: “Cool“
Orange: “Dehumidify“
Yellow: “Fan“
Orange LED display
for the fan speed, with
high/medium/low speed
“High“/“Med“/“Low“
Green LED display
for the time delay, “Timer“
Green “Room Temp“ LED
(If this LED lights up the current
room temperature is shown in
the display )
Green “Set Temp“ LED
“°C/°F“ toggle button
(only on the remote control)
Control panel
„Mode“ selection
■ „Cool“
The device is used to cool the
room. It filters and dehumidifies
the air and thus creates a pleas-
ant room climate.
■ „Dehumidify“
In the “Dehumidify“ mode, hu-
midity is removed from the air.
■ „Fan“
The device circulates the air,
filters it, and creates an even air
flow..
Infrared remote control
Infrared transmitter
Infrared receiver
The system can be operated by means of the control panel on the device or via the standard infrared remote
control unit. The functional operation of the buttons among themselves is identical, however, the designation
can vary. The batteries must be correctly inserted before the infrared remote control is used.
Operation
REMKO MKT
6