QVidium QVENC Encoder v17 - Manual (Page 61)

User’s Manual v.17 QVidium
®
H.264 HD Video Codecs ™
Copyright 2011-2015 QVidium
®
Technologies, Inc. Page 61 of 73
Destination IP Address or Hostname: This specifies the IP address or Hostname for the
Video/IP stream.
UDP Port: This specifies the UDP port number (P), base 10, for the Video/IP stream.
TS packets per IP packet: This field allows specification of the number of 188-byte MPEG-2
Transport Stream packets per IP packet. The standard MTU for Ethernet packets permits a
maximum of 7 TS packets per IP packets, which is the default.
ARQ
The parameters below ONLY pertain to ARQ error correction. They will be ignored when ARQ IP
Transport is not selected.
ARQ Port: By default, ARQ normally sends upstream retransmission request packets on UDP port
7020. You can change this ARQ Port setting to any valid and non-conflicting UDP port. However,
you must make certain that you specify the same port number at both the encoder and the
decoder.