Quintum Technologies CDR - Manual (Page 5)

Quintum Tenor CMS CDR Page 3
Syntax for the CDRFormat command is as follows:
config-CDRServer-1# set cdrformat {x}
or
config-CDRServer-2# set cdrformat {x}
Table 1: CDR CLI Commands
Command Description
CDRFormat This configuration parameter command is used to choose which of the four (4)
possible Call Data Records output formats you would like sent to your CDR
Server, each with or without Session ID functionality (see below).
CDRServerIPAddr IP address of the CDR server (used to establish connection with CDR server).
CDRServerPort The Application Port number(s) used by the CDR server(s). (Used when the
CMS establishes connection with CDR server.) (Valid values are 9002, 9003,
9004, and 9005)
CDRPassWord Password to be used by the CDR server(s) to gain permission to access the
CMS.
Table 2: CDRFormat Parameter Settings
Setting Description
0 Gives the Standard CDR output (See next page for output details)
1 Gives the Extended CDR output. (See next page for output details)
3 Gives Extended-CMS CDR output. (See next page for output details)
4 Gives Extended-CMS+ CDR output. (See next page for output details)
100 Same data stream as Selection 0, but adds the Session ID functionality.
101 Same data stream as Selection 1, but adds the Session ID functionality.
103 Same data stream as Selection 3, but adds the Session ID functionality.
104 Same data stream as Selection 4, but adds the Session ID functionality
199 Same data stream as Selection 104, but adds the trunk id parameters (if
configured) and the disconnect leg