PSE Archery TAC 2013 - Manual (Page 4)

CROSSBOW OWNER’S GUIDE
®
4
PREPARING THE AR-15 FOR PSE TAC
CROSSBOW INSTALLATION
1. Place the safety lever in the “SAFE” position.
2. Remove the magazine and open the chamber to remove
the round that may be in the chamber.
3. Remove all shoulder straps.
4. Close the bolt.
5. Remove take-down pins and carefully follow the
instructions provided with the AR-15 to remove the
upper receiver.
PSE TAC CROSSBOW ASSEMBLY
1. Install the prod assembly onto the barrel assembly using
the two 1/4”-28 flathead screws provided
in the kit (Figure 1.) Install the prod on TAC Elite
crossbow in the same manner.
2. The hammer of AR-15 must be in the cocked position
before installing the crossbow barrel. (Figure 2.) After
hammer is cocked, place the safety lever in the SAFE
position.
3. Fit the AR-15 lower receiver onto the front pin hole of the
crossbow barrel and secure the pin. (Figure 3.)