PSE Archery TAC 2013 - Manual (Page 10)

CROSSBOW OWNER’S GUIDE
®
10
COCKING & LOADING (CONT.)
4. With the arrow in place, crank the string back to full
draw. The draw mechanism will stop when it reaches
the end of its travel.The draw position pin must be in
the notches in the barrel when full draw is reached.
(Figure 11.)
CAUTION: DO NOT OVERCRANK.
ALWAYS POINT THE
CROSSBOW IN A SAFE DIRECTION.
5. There should NOT be a gap between the draw position
pin and the notch as shown in Figure 12. The draw
position pin should be in contact with the notch as
shown in Figure 13.
6. Release tension on the cocking rope by applying
pressure to the crank so that the ratchet release lever
can be pressed. Hold down the ratchet release
and crank the handle in the LET DOWN direction until
the draw position pin rests on the front of each notch.
Fig. 11
Draw Position Pin