PSE Archery Dream Season RDX 2015 - Manual (Page 6)

CROSSBOW OWNER’S GUIDE
®
MOUNTING THE QUIVER
Parts to install quiver:
A. Quiver
B. Quiver mount bracket
C. Hex Screws & Wrenches
1. Attach the mounting bracket to the base of the receiver as show in Fig. 5a.
Tighten it with the enclosed hex key. Fig. 5b
3. Tighten the mounting bracket’s screws with the attached hex wrench and
make sure it’s firmly attached. Fig. 6a
4. Slide the quiver into the groove on the quick release mounting
bracket. Make sure the locking lever is in the open position. Fig. 6b
5. Lock the quiver by turning the locking handle, you can unlock and remove the
quiver by opening the locking handle. Fig. 7a and Fig 7b.
C
6
SCOPE INSTALLATION & SETUP
1. Slide 4x32 scope (Fig. 8a) over rail mount. Tighten with included hex wrench.
Fig. 8b (Note: The scope will only slide if the mounting bolts are removed,
otherwise it must be located to a desired position on the scope rail.
2. Begin adjusting your scope by sighting your crossbow at the closest yardage
from which you plan to hunt. Ex. 10 yards = top line of crosshairs.
3. Once you’ve established your closest range, progressively move back in yardage
to determine the yardage points for the remaining lines in your crosshairs.
4. Because all of the sight lines move together, you will make adjustments based
on your closest sight point by using the Windage (side) and Elevation (top)
knobs.
NOTE: SCOPE RETICLE & KNOB MAY VARY FROM MODEL TO MODEL.
ALSO, BE CAREFUL NOT TO MOVE THE SCOPE BASE WHEN MAKING YOUR
ADJUSTMENTS.
B A