PSE Archery Dream Season RDX 2015 - Manual (Page 4)

CROSSBOW OWNER’S GUIDE
®
4
DREAM SEASON RDX CROSSBOW
Before assembling your crossbow please check to see if all crossbow parts are included:
1- Prod, 1- Stock, 1 - Scope, 1 - Prod Bolt, 1 - Washer (not shown), 2 - Allen Wrenches, 1
- Rail Lube (not shown), 1 - Quiver Mount, 1 - Mouting Bracket Extension, 1 - Foot Stirrup,
and 1-Quiver. (Fig. 1 & 2). If any of these parts are missing please contact PSE Customer
Service.
Slide prod nut into hole just in front of barrel grip. Make sure center threaded hole lines up
with hole in front of barrel. Fig. 3.
Connect the barrel and the prod assembly by inserting the cable slide and cables into the
slot on the barrel as shown in Fig. 4. Be sure the concave side is facing up to match with the
contour on the inside of the barrel.
Insert the foot stirrup into the two holes on the front of the prod. Fig 4a. Make sure the two
notches in the foot stirrup are facing towards the bolt used to secure the stirrup and prod.
Use the hex key to tighten the bolt as shown in Fig. 4b.
NOTE: Cable damage WILL occur if you do not use the slide. Any damage incurred due to
improper set-up will not be covered by your warranty.
Comfort Molded Grip
Full-length barrel foregrip
Large Boot Style Foot
Stirrup
Machined Barrel/Stock
4x32 Multi-Range Scope
Precision Trigger / Auto Safety
Fig. 1
Cam
Limbs
Quiver Prod Assembly