beautypg.com

Posiflex DS-210 User Manual

Page 18

background image

Toggle SW1 Pos. 6 to “ON’ for USB interface or to “OFF” for the other
interface (Serial, Parallel, LAN, Wi-Fi or the like).

Switch position 7 defines the auto cutter. When it is essential to enable the
paper auto cut function, toggle the switch position to “OFF”. On the other hand,
the auto cutter function will be disabled when it is toggled to “ON”.

Switch position 8 defines the firmware update function. If the printer needs to
update the firmware, please set to “ON” position. In order to operate perfectly,
please set in “OFF” when the printer does not need to update the firmware or
in normal situation.

Each factory default setting of the positions of switch 1 is listed below.

Position

1

2 3 4 5 6 7 8

Default setting

ON

ON

OFF OFF OFF OFF OFF OFF

Setup through software switch:
The DS-210 end users are allowed to set up the DS-210 printer through the
software switch setting, which means that software utility must be used for
setup of other functions. Please visit our web site

http://www.posiflex.com/up/Download/downlaod

to download the DS-210

Thermal Printer Software Switch Utility for Windows. Software switches
are divided into SW1, SW2, SW3, and SW4. After downloading the utility,
refer to the Help file in the utility folder for the details before operating the
software switch setup.

Please reboot the printer after the switch settings are done.

18

This manual is related to the following products: