Posiflex DS-210 - Manual (Page 16)

9. The WIFIConnectTool is opened. Select
Access Point (1) and tap Go (2) to make
your tablet PC start to connect to the DS-
210 in the Infra mode.
10. When your tablet PC is successfully made
to operate in the infra mode, you will see
the “OK” message.
2
1
Note: When your tablet PC operates in the infra mode, it is not
determined that your tablet PC connects to the DS-210 printer and you
must check whether or not your tablet PC connects to the access point to
which the DS-210 printer connects.
Status LED Indicator
After supplying power to the DS-200/210, powering ON the dock station, and
even enabling the Wi-Fi module of the DS-210, you can read the system
operation status from the LED indicators on the dock station. The LED status
is described below.
LED Status Description
Solid orange System standby
POWER LED
Solid blue System ON
Flash red Cutter abnormal
Solid red Cover open Error LED
Flash red Operation temp. high
Paper-out
LED
Solid red
Paper out
Wi-Fi LED Flash green
1. System standby but not
connected
2. Connection of peer to peer
3. Data transmission between
peers
16