Posiflex JIVA KS-7310 - Manual (Page 9)

Part 9
CABLE ROUTING
DISCONNECTING ALL CABLES
With the LCD panel turned to most backward position, the main I/O connector
area will be easily accessible at bottom side of the main unit. Please first note
orientations of every existing cable connection and then disconnect every
cable properly before any further reconfiguration of cable connections. Please
note that the click lock spring has to be pressed down prior to pulling out the
connector such as the LAN port or the 2 alternate RJ45 form COM ports.
Please also note that the fixing screws have to be loosened free prior to
disconnection such as the 2 regular DB9 form COM ports. Please always hold
the connector head instead of pulling on the cable wire when disconnecting
any connector. Failure to do this could damage the cable and jack that is
considered as an artificial destruction. Damages due to incorrect
disconnection operation are not covered by product warranty!
OPENING BASE BACK COVER
In order to settle the touch terminal
properly in a point of sale system, all
the cable connections have to be
routed through its base. Therefore,
please observe the side view pictures
of the base trunk at the left and
release the triangle marked hooks to
remove the back cover.
CABLE ROUTING IN BASE
For cable routing in the undetachable mini slim base,
please refer to the picture at left. There are 2 cable tie
holder slits on the metal bracket for the trunk as
arrowed in the picture. Hold all the external cables
with a cable tie through the right cable tie holder slit
and leave the cables tied to the left holder slit. Have all
cables to pass through the oval hole on the trunk to
come out of the front side of trunk.
Connect all the
cable ends to main unit. Be sure not to damage any
cable during this operation.