Posiflex JIVA KS-7310 - Manual (Page 11)

Part 11
CONNECTING CASH DRAWER (OPTION)
The RJ11 connector in I/O area of the system can be used for controlling most
of the common cash drawers available on the market. However, it is most
recommended to use Posiflex CR-2200, CR-3100, CR-4000, CR-4100 or CR-
6300 for best compliance to operate the opening mechanism and to monitor the
drawer open status.
The user may also purchase the optional 2-in-1 cash drawer control cable to
control 2 cash drawers in 1 port. It has a 6-pole plug at one end and two 8-pole
plugs at the other. The 6-pole plug should be inserted in the connector marked
“CR” found in the I/O area in the system. Each 8-pole plug should be inserted
into the connector marked “signal cable from POS Printer” at the rear of one of
the cash drawers.
Wi-Fi USB ADAPTER (OPTION)
Wi-Fi USB adapter is a USB based Wi-Fi module utilizing the high-speed data
communication at up to 150 Mbps. It realized in the 2.4G Hz radio band by
adapting IEEE 802.11N wireless standard.
Please refer to the User’s Manual attached (content in the CD/DVD delivered)
with this option for its driver setup or utility.
Do not connect the Wi-Fi USB adapter to the system before installation
the driver and utility.
CONNECTING CABLES
To have the re-assembled main unit with stand assembly ready for operation,
please connect all required cables to the appropriate connectors. Please make
sure that each connector is connected to the correct port with the correct
orientation. Damages due to incorrect connection or orientation are not
covered by product warranty!
Some connectors like the LAN, COM or CR connector have to be gently
inserted until a click is heard. It is recommended that connectors such as the
COM1/2 connector be screwed into place once seated. Adjust the slack of each
cable. Re-adjust the tilt angle of the screen for best viewing. Connect the
cables to appropriate external devices through the cable exit at the bottom of
stand assembly. Please make sure that each connector has to be connected to
the right device in the right way.
CAUTION: On doing any insertion or extraction of any connector, please
always hold the connector head itself instead of pulling on the
cable wire. Failure to do this could damage the cable and jack
that is considered as an artificial destruction and is not
covered by the warranty.