Posiflex JIVA KS-7310 - Manual (Page 13)

Part 13
Hardware Power Switch
The power switch located at side of the main
unit is a tactile pushbutton switch. This
switch controls the power on/off of the
system. This switch turns the system on
when pushed only and external power is
present. This switch turns the system off
when pushed again during power on status.
However, if the system hangs due to any
reason such as software resource conflict a
simple push on the switch may fail to turn
off the power. In this case, please utilize the
forced power off feature by pressing the
switch and holding for within 10 seconds.
There must always be at least 10 seconds waiting before switching on again
after the system is powered off successfully.
Automatic Power On Control
The system may also turn on according to some preset conditions such as
Modem Ring Up and LAN Wake Up.
To utilize Modem Ring Up function, the user should enter the BIOS setup by
pressing “Del” key at system boot up, choose in “Power Management Setup”
and make the “Power On by Ring” enabled for Modem Ring Up. Save the
configuration and exit the BIOS setup program. The Preset Power On Control
will then be ready. For LAN wakeup, the item “Power On by LAN” must be
enabled in “Power Management Setup” and an operating caller system
connected through LAN to the system is required. It also requires a qualified
networking technician to check the LAN chip ID of the system for the caller
system to wake up.
When the terminal is turned off after a successful boot up with external power
continuously supplied, the preset automatic power on functions will keep
monitoring for the preset conditions and turn on the system when the preset
conditions are met.
Please note that if the terminal is improperly turned off before a complete boot
up procedure, the above preset power on control functions will be disabled
until next turning off after a complete boot up.