Base mount upgrade kit (option), Preparing the main unit – Posiflex JIVA KS-7310 User Manual
Page 10
Part 10
BASE MOUNT UPGRADE KIT (OPTION)
For the system with mini slim base, the
LCD customer display PD-309/U or the
VFD PD-2605/U can be attached to
either rear corner of base bottom. Refer
to the pictures at right. Use the 3
attached screws to fix the metal base
plate of the PD to bottom plate of mini
slim base at the circled positions. Connect the interface cable
to go into the base through cable exit arrowed at right to the
main unit.
PREPARING THE MAIN UNIT
On the back of the
main unit, there is a
service window visible
through the oval cable
passage when the base
back cover is removed.
It is recommended to
Remove the 2 hinge fixing screws as triangle pointed in the upper right picture
and remove the arrowed service window lock screw to open the cover plate
and find several jumpers and a reserved LPT port as illustrated the lower right
picture.
Please consult your dealer for technical support on setup of these
jumpers.
Please note that only those qualified technicians may adjust in the
service window with information from Posiflex and the contents in the service
window may change without notice as time develops.
The option LPT
conversion cable should be applied to the connector as arrowed in left picture
below.
Route the
conversion
cable
from bottom side of
the service window
plate to connect the
usual
cable
for
parallel
device.
Please notice that
when using the LPT conversion cable, the metal plate of service windows
can not be use and the service windows will be open!
LPT Connector
Service Window Lock Screw