Posiflex JIVA KS-7215 - Manual (Page 9)

Part 9
DISCONNECTING ALL CABLES
After removal of the cable cover, the connector area will be accessible then.
Please first note orientations of every existing cable connection and then
disconnect every cable properly before separating the main unit from the
adjustable stand assembly. Please note that the click lock spring has to be
pressed down prior to pulling out the connector such as the LAN port or the
CR port or the alternate RJ45 form COM3/4 port. Please also note that the
fixing screws have to be loosened free prior to disconnection such as the 2
regular DB9 form COM ports or the VGA port. Please always hold the
connector head instead of pulling on the cable wire when disconnecting any
connector. Failure to do this could damage the cable and jack that is
considered as an artificial destruction. Damages due to incorrect
disconnection operation are not covered by product warranty!
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system, all the
cable connections have to be routed through its base, either slim or universal.
Therefore, please observe the procedures from A to C below to separate the
main unit from the slim base stand assembly after all cables in cable cover
disconnected.
Step A: Prepare a soft clean flat surface, such as a piece of cloth on the desk to
seat the front surface of main unit
Step B: Press the Lock/Release button for main unit detach and meantime.
Step C: Slide the base stand assembly to left to separate the main unit from
base stand.
C
A
B
C
A
B
Gen.5 th base stand.
C
A
B
Gen.6 th base stand.