Posiflex JIVA KS-7215 - Manual (Page 11)

Part 11
INSTALLING UPS BATTERY (OPTION) For Gen 5 Base
When the KS-6915/6917/7215/7217 systems are ordered with the UPS battery,
the UPS battery is separately stored in the carton at delivery. Please take the
battery out and place it into the battery compartment by first putting in the end
of UPS battery without cable in the UPS battery end hold of the base and have
the end of UPS battery with cable held against the UPS battery stopper in the
base as indicated in picture above. Route the UPS battery cable to reach for
main unit through the cable passage in the base. Apply the bottom plate and
screws the UPS battery will be held in place. Connect the UPS battery to UPS
battery connector of the main unit only when the system is about to power
up for operation. Always disconnect the UPS battery when the system is to
be left powered off for more than few days. Please pay particular attention to
the environment requirement for UPS battery in next chapter “USING THE
TOUCH TERMINAL”.
CABLE PASSAGE FROM BOTTOM For Gen 5 Base
Place all the cables required for
connections to the main unit except
those for the integrated attachment
through the front part inside the
base stand assembly. Be sure not to
damage any cable during this
operation.
Now, turn the adjustable base stand assembly back to normal orientation and
arrange all cables to come out of the area for mounting main unit from the
bottom edge for ease of later operation.
3
4
2
7
6
Inside Gen 5
1
5
1. Cable Exit
3. Cable Tie for Option HDD Cables
2. UPS Battery Stopper
4. Cable Passage To Main Unit For
Desktop Mount Application
6. Option HDD Conversion Board
7. Option HDD Bracket
5. UPS Battery End Hold
Route Cables through
Front Part
Connect this End
to Main Unit