Posiflex JIVA KS-7215 - Manual (Page 13)

Part 13
Then, hold the monitor with bracket and aim to join
bracket which just fixed on the main unit and fasten these 3
pcs short screws which circled in the right picture.
Next, please connect the VGA Cable to the LM VGA port
and route the VGA cable through the cable exit of the base
stand to the system VGA ports.
Note: When KS-6915/6917/7215/7217 series equipping with LM-80X5
series 15” second LCD monitor is must be upgrade system power adaptor
from 60W to 80W.
CONNECTING CASH DRAWER (OPTION)
The RJ11 connector in I/O area of a KS-6915/6917/7215/7217 system can be
used for controlling most of the common cash drawers available on the market.
However, it is most recommended to use Posiflex CR-2200 or CR-2210 or
CR-3100 or CR-4000 or CR-4100 or CR-6300 for best compliance to operate
the opening mechanism and to monitor the drawer open status.
This cable of Cash Drawer has a 6-pole plug at one end and an 8-pole plug at
the other. The 8-pole plug should be inserted into the connector of the cash
drawer which marked “Signal”. The 6-pole plug should be inserted in the
connector marked “CR” which can found in the main connection area in the
system.
The user may also purchase the optional 2-in-1 cash drawer control cable to
control 2 cash drawers in 1 port. It has a 6-pole plug at one end and two 8-pole
plugs at the other. The 6-pole plug should be inserted in the connector marked
“CR” found in the I/O area in the system. Each 8-pole plug should be inserted
into the connector marked “signal cable from POS Printer” at the rear of one of
the cash drawers.
CONNECTING CABLES
To have the re-assembled main unit with stand assembly ready for operation,
please connect all required cables to the appropriate connectors. Please make
sure that each connector is connected to the correct port with the correct
orientation. Damages due to incorrect connection or orientation are not
covered by product warranty!
Some connectors like the COM3/4, LAN or CR connector have to be gently
inserted until a click sound is heard. It is recommended that connectors such as
the COM1/2 and VGA connector be screwed into place once seated.
Re-adjust the tilt angle of the screen for best viewing. Connect the cables to