Pertech 6100 Series - Manual (Page 8)

Pertech Resources Inc. October 2007 220350A 4
Connecting the Cables
Caution: Be sure the power switch is turned off before
connecting cables.
1. Make sure the unit is on a level surface.
2. Make sure the Scanner is powered off.
3. Connect the Power Supply to the Scanner.
3. Connect the Power Supply to the Power Source.
4. Connect The USB cable to the back or the scanner.
5. Load drivers on the PC (See Page 5 of this manual).
6. Connect the USB Cable to the PC and turn the scanner on.
USB Interface
Power Connection
Power Switch
Cables and Connections
USB 2.0 Interface
Standard Pinout
Pin 1 EOT/VCC
Pin 2 D-
Pin 3 D+
Pin 4 GND
Pin 5 GND
Pin 6 GND
The USB cable may be attached or detached when the
system is on. When Using the USB interface the Win-
dows® Operating System will automatically install the
USB port driver. Pertech has available scanner drivers
at www.pertechresources.com.
Warning: When Hot Swapping USB cable
make sure that cable is installed into the
correct connectors or damage to the scanner
could result.
USB Cable Part
Number 106356011
Printer View