OWON HDS1021M - Manual (Page 49)

OWON HDS1021M Handheld DSO & DMM 8-Advanced Function of Oscilloscope
1. Press MENU, the function menu will appear on the right of the screen.
2. Press MENU ▲ or MENU ▼ and select DISP SET, four options will show at the
bottom of the screen.
3. Press F4 and select Cymometer to ON, then the frequency of the signal will display at the
right
corner
of the screen.
See the following figure 42:
Figure 42:
8.7 Waveform Saving Setups
The oscilloscope can save 4 waveforms, which can be displayed on the screen with the present
waveform. The recalled waveform saved in the memory cannot be adjusted.
The waveform saving /recalling menu is described in the following list.
Function menu Set up Description
WAVE A, B, C and D Select the address for saving or recalling a waveform.
Save Store the waveform into the selected address.
Show
ON
OFF
Close or start displaying the waveforms stored in address
A, B, C or D.
To save a waveform in address A, do the following:
1. Press the MENU key and the function menu appears at the right of the screen.
2. Press the MENU ▲ or MENU ▼ key to select the WAVE SAVE. Four items selectable are
displayed at the bottom of the screen.
3. Press the F1 key to select the address A.
4. Press the F2 key to save the waveform in address A.
To display the saved waveform on the screen, do the following:
5. Press the F3 key to select ON and the waveform saved in address A will be displayed on the
screen in green color.
The display color is green, and the zero point of waveform , voltage and time is purple.
４２