OWON SDS Series User Manual
Sds series, User manual
This manual is related to the following products:
Table of contents
Document Outline
- Table of Contents
- 1. General Safety Requirements
- 2. Safety Terms and Symbols
- 3. General Characteristics
- 4. Junior User Guidebook
- Introduction to the Structure of the Oscilloscope
- User Interface Introduction
- How to Implement the General Inspection
- How to Implement the Function Inspection
- How to Implement the Probe Compensation
- How to Set the Probe Attenuation Coefficient
- How to Use the Probe Safely
- How to Implement Self-calibration
- Introduction to the Vertical System
- Introduction to the Horizontal System
- Introduction to the Trigger System
- 5. Advanced User Guidebook
- How to Set the Vertical System
- Use VERTICAL POSITION and VOLTS/DIV Knobs
- How to Set the Horizontal System
- How to Set the Trigger System
- How to Operate the Function Menu
- How to Implement Sampling Setup
- How to Set the Display System
- How to Save and Recall a Waveform
- How to Cut and Recall a waveform
- How to Record/Playback Waveforms
- How to Implement the Auxiliary System Function Setting
- How to Measure Automatically
- How to Measure with Cursors
- How to Use Autoscale
- How to Use Built-in Help
- How to Use Executive Buttons
- 6. Communication with PC
- 7. Demonstration
- 8. Troubleshooting
- 9. Technical Specifications
- 10. Appendix