How to use autoscale – OWON SDS Series User Manual
Page 83
5.Advanced User Guidebook
Cursor2 by turning the VERTICAL POSITION knob of CH1 and CH2.
Increment window shows two cursors difference value and the present position
(see Figure 5-57).
Figure 5-75 wave of Freq cursor measurement
How to Use Autoscale
This is a very useful function for first time users to carry out a simple and quick test
on the input signal. The function is applied to follow-up signals automatically even if
the signals change at any time. Autoscale enables the instrument to set up trigger
mode, voltage division and time scale automatically according to the type, amplitude
and frequency of the signals.
Figure 5-76 Autoscale menu
The menu is as follows:
Function Menu
Setting
Instruction
78
This manual is related to the following products: