OWON SDS Series - Manual (Page 75)

5.Advanced User Guidebook
How to Measure Automatically
Press the Measure button to display the menu for the settings of the Automatic
Measurements.
The oscilloscopes provide 24 parameters for auto measurement, including Vpp,
Vmax, Vmin, Vtop, Vbase, Vamp, Vavg, Vrms, Overshoot, Preshoot, Freq, Period,
Rise Time, Fall Time,
Delay A→B , Delay A→B ,+Width, -Width, +Duty, -Duty,
Cycle rms, Cursor rms, Duty cycle, Phase.
The menu is displayed as Figure 5-48.
Figure 5-66 Measure Menu
The "Automatic Measurements" menu is described as the following table:
Function Menu Setting Description
Add
Type Press F1 ,show the measure types
Source
CH1
Select the source
CH2
Show all Show all the measures on the screen
Add
Add the selected measure types (shown
at the left bottom, you could only add 8
types at most)
Remove
Remove all Remove all the measures
Type
Turn the M knob, select the types need
to be deleted.
Remove Remove the chosen measure type
Measure
The measured values can be detected on each channel simultaneously. Only if the
waveform channel is in the ON state, the measurement can be performed. The
70