OpenEye OE2-E480 - Manual (Page 33)

29081AD 33
Sensor Setup
Sensor Setup:
1. Use the arrow buttons to select Sensor 1 and press
ENT to change to N/O (Normally Open) or N/C
(Normally Closed).
2. Repeat for all sensors.
3. Select SAVE and press ENT to save settings and exit
SENSOR SETUP.
Relay Setup:
1. Use the arrow buttons to select Relay 1 and press
ENT to turn OFF and ON.
2. Repeat for all relays.
3. Select SET and press ENT.
4. Select SAVE and press ENT to save settings exit
SENSOR SETUP.
Action Setup
CH –  Channels 1~8 /  Channels 9~16
RELAY – Assign a relay to each camera channel and define
delay and duration times.
IMAGE – Enable popup image in remote software.
PRESET – Enable camera to move to a preset position
when an event occurs.
DISPLAY – Set number of seconds to display image when
an event occurs [0-100 sec].
Check to enable: EVENT MESSAGE – ON/OFF
EVENT POPUP – ON/OFF
EVENT BEEP – ON/OFF
EA (Emergency Agent)
The Emergency Agent is a utility that streams video across
a Local Area Network to a Client PC when an alarm is
detected on the DVR unit. The streaming video can be
stopped, played forward, backwards, in slow motion or real
time.
Send event information to a remote client.
1. Select ENABLE and press the ENT button to select
ON.
2. Enter the IP ADDRESS of the remote client.
3. Enter the PORT NUMBER.