OpenEye OE2-E480 - Manual (Page 20)

20
CONNECTION GUIDE
CONNECTING THE MONITOR
There are three available monitor outputs on the E-Series DVR.
• Composite Monitor output for CCTV monitor – BNC (Marked MAIN)
• VGA output for VGA monitor – Mini-Sub D15
• S-Video output - Mini-Din 4
VIDEO INPUTS AND LOOPING OUTPUTS
The E-Series DVR comes with 16 BNC video inputs on the rear of its chassis. Each video input has a corresponding looping
BNC output beneath it for passing the video signal to another monitoring/recording device.
CONNECTING TO A NETWORK
Use the RJ45 jack on the rear of the DVR when connecting to a network.
CONNECTING AUDIO
To record audio on the DVR connect the audio source to the Audio In Port (White) on the back of the chassis.
To listen to live or recorded audio connect the Audio Out Port (Red) to an amplified speaker system.
Note
The DVR audio output is a line level source which requires an amplified speaker system. The audio input can be from
an amplified source or directly from a microphone.
CONNECTING A PTZ CAMERA
The RS485 connector can be used to control Pan / Tilt / Zoom (PTZ) cameras. See the
PTZ camera manufacturer’s manual for configuring the RS485 connection.
Note
Use the RS485 connector for external control systems such as a control
keyboard. Connect RX-/TX- and RX+/TX+ of the control system to the TX-
/RX- and TX+/RX+ (respectively) of the DVR.
RJ45