ONICON System-10 BACnet User Manual
Page 16
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
System-10-BAC Network Interface Installation Guide 04/14 - 0652-8 / 16957
Page 16
8.
When the address change is complete, the following message will appear. You
must cycle power to the System-10 for the change to take effect.
1.6.3 Changing the Gateway Address
Changing the gateway address requires the use of RUInet utility software and a PC with
an Ethernet card and an available port. Assuming the display is programmed with the
default address (192.168.1.24) the host PC must be configured to operate with an
IP address of 192.168.1.1 and a subnet mask of 255.255.255.0. RUInet is available for
download from the ONICON web site, www.onicon.com.
1.
Load RUInet and configure the PC as necessary.
2.
Connect an Rj45 Ethernet cable between the PC and the display and power the
System-10. Allow 60 seconds for the display firmware to cycle through start-up
diagnostic routines.
3.
Open RUInet.
4.
From the Remote User Interface main menu (shown below) select option “I”,
Change IP Address.