ONICON F-3100 Series - Manual (Page 40)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-3100 Flow Meter Manual 06/14 - 0670-7
Page 3
Step 1
Remove the retaining
nut and black plastic
plug from the center
strain relief on the
enclosure and feed the
nut over the end of the
cable. Then feed the
cable through the strain
relief.
Section 3: Wiring the Transmitter
Step 2
Attach the green
connectors to the
end of the cable.
Numbers on each
wire correspond to
the numbers on the
connectors.
Step 3
Re-install the
connectors and tighten
the strain relief.
Re-install the power
cable and connector. Step 4
Remove the o-ring
from the remote
mount bracket and
place it into the gland
on the bottom of the
enclosure as shown.
Step 5
Attach the mounting
bracket using the
screws and lock
washers supplied
in the kit. Step 6
Close and fasten
the cover.
IMPORTANT NOTE
Transmitter programming must be changed to complete the remote mount installation.
i