ONICON F-3200 Series - Manual (Page 39)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-3200 Flow Meter Manual 05/14 - 0671-12 / 18325
Page A-3
Step 1
Remove the retaining
nut and black plastic
plug from the center
strain relief on the
enclosure and feed
the nut over the end
of the cable. Then
feed the cable through
the strain relief.
Repeat process for
second cable.
Section 3: Wiring the Transmitter
Step 2
Attach the green
connectors to the
end of the cable.
Numbers on each
wire correspond
to the numbers on
the connectors.
Step 3
Re-install the
connectors and
tighten the strain
relief. Re-install the
power cable and
connector. Step 4
Remove the o-ring
from the remote
mount bracket and
place it into the
gland on the
bottom of the
enclosure as shown.
Step 5
Attach the mounting
bracket using the
screws and lock
washers supplied
in the kit.
IMPORTANT NOTE
Transmitter programming must be changed to complete the remote mount installation.
i
Step 6
Close and fasten
the cover.