ONICON F-3200 Series - Manual (Page 38)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-3200 Flow Meter Manual 05/14 - 0671-12 / 18325
Page A-2
Step 1
Remove the cover and cir-
cuit board from the remote
mount junction box.
Section 2: Installing the Remote Mount Junction Box
Step 2
Feed the cables through the holes
in the bottom of the junction box
and mount it in place. Step 3
Re-install the circuit board.
Step 4
Attach the cables
to the terminal
blocks as shown. Step 5
Install the remote
mount cables through
the strain relief
supplied with the
junction box. Connect
cables to the numbered
terminal blocks as
shown.
Step 7
Re-install the cover.
(Note: Each wire is labeled with a number that
corresponds to a terminal location.)
Step 6
Cables should
be connected
as shown.