Northern Airborne Technology THxxx - Manual (Page 78)

Tac/Com Control Head Manual SM06 Rev. 4.10
3.3 Initial Operation
3.3.1 Power-up Help
Turn the Tac/Com system on by rotating any radio volume control away from the OFF
detent position. The software revision number will be briefly displayed, followed by a
screen presenting an option for use of the on-line HELP system, as shown below.
If help is selected (i.e., the HELP button is pushed), the control head will present a
tutorial on the operation of each control head feature. To advance through the tutorial,
press HELP after reading each screen. To exit this initial help function at any time,
press the RADIO button, and the control head will begin normal radio operation.
3.3.2
Initial Operating Display
If help is declined (by using the RADIO button as directed), the control head will display
a summary of the installed functions and current settings for each radio (this feature can
be disabled in the installation set-up for faster start-up). Once all of the functions have
been displayed, the radio will be ready for normal operation.
Once normal control head operation is selected, the display will install the radio and its
settings as specified by the interface card and software set-up instructions. This will
produce the following system message on the control head:
HE LP=Instruction
RADIO=Operation
NAT NT-150
Page 3-2 Jan 4, 2006
ENG-FORM: 806-0106.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.