Nortec MLP RO pump station - Manual (Page 5)

TI071GB-02 /06.11.09/LJ 5/12
Selecting RO type
The software of the control is made universally as to language choice choice of MLP RO-
type. The choice of RO-type takes place at the first pass by the fact that VERS RO xxx 1003
appears on the display.
Here you choose between different options. (Options are only possible together with the
hardware changes)
Selecting options
You can choose between following options
- Load-dependent by-pass - fan control - raw water mixer.
The choice takes place as to the diagram below.
The screen will display VERS. 60_0 . Then press “Enter”. The cursor will now
blink under 0. Use the arrow keys to make the choice followed by “Enter”
60 0 60 1 60 2 60 3 60 4 60 5 60 6
Load-dependent by-pass X X X
Raw water mixer
X X X
Fan control
X X X
Selecting language
Having chosen RO-type, language choice must be made. The display shows LANGUAGE
1/3 xxx - where the variable is set to 1 - for DANISH - 2 - for ENGLISH - 3 - for GERMAN.
Version 60 0 rel 1006 >
To be used for 1 department with pressure release valve or for 4 departments with solenoid
valve sets.
This has to be set up during the initial start.
Ex.1: 1 department with pressure release valve on the pump station:
Choose version: 60 X
Choose number of departments: 1
Press 2 for English
Press 0 for no membrane flush during start
Press F5
Type in password: 8599
Choose 0 at Valve set (default is 1)