Dixon 13631-0702 - Manual (Page 37)

37
CAUTION
HOT oil may cause burns. Allow
engine to cool before draining oil.
CARE AND MAINTENANCE
CHANGING THE ENGINE OIL:
1. The “Dapco” oil drain valve is located on the left
side of the engine crankcase.
2. Place a suitable container under the drain valve
hose.
3. To drain, turn hex head valve stem counter-
clockwise with 10mm wrench or socket. Open to
full open (approximately 7 turns).
4. After engine is drained, tighten hex stem.
5, Change oil filter (3304 & 3363 only).
6. Fill with oil (see steps below).
NOTE: Refer to engine manufacturer’s recommendations
for frequency of oil changes.
Hex Head Valve Stem
OIL FILL:
1. Clean any spilled oil from engine and chassis.
2. Refill engine with type, and quantity of oil
recommended by the engine manufacturer in
engine literature.
PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS.
PROTECT YOUR ENVIRONMENT.