Specifications, Model ztr 3304 – Dixon 13631-0702 User Manual
Page 14
14
SPECIFICATIONS
Model ZTR 3304
CHASSIS:
Twin 12 gauge side frames and 7 gauge transmission
and engine base plate.
BODY:
All body parts are made of rotational molded poly-
ethylene. Front body contains access panel for
battery service. Seat tilts forward to allow trans-
mission service.
MOWER DECK:
11 GA stamped steel construction. Single 30" cut
blade. Cut height approximately 1" to 4" via 7 position lift
handle.
BLADE DRIVE:
Mechanical; hand lever engagement.
TRANSMISSION:
Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
ENGINE:
13.5 HP Briggs & Stratton Intek,4-Cycle, Single
Cylinder, Overhead Valve, Air-Cooled, Gasoline,
Vertical Shaft, Cast Iron Cylinder, AVS (Anti Vibration
System), Pressure Lube & Filter
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on
parking brake and blade drive.
TIRES:
Front
11 X 4.00-5 ribbed tread.
Rear
16 X 6.50-8 Turf Trac R/S tread.
RECOMMENDED
Front
16-21 PSI
TIRE PRESSURE:
Rear
8-14 PSI
CAPACITIES:
Fuel
2.0 gallons
Engine
1.25 quarts
DIMENSIONS:
Width
32.5" outside rear wheel measurement.
Height
32.0" to top edge of seat.
Length
65.5" hitch tab to front bumper.
Weight
440 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.