Dixon 13631-0702 - Manual (Page 35)

35
CARE AND MAINTENANCE
Deck Removal - Electric Clutch
Model 3363
1. Place cut height lever in lowest cut position.
2. Loosen nut on belt idler shock mount until belt
can be removed from electric clutch pulley on
the bottom of the engine. Refer to illustration.
3. Remove hair pin cotter and washer from one end
of deck support cross shaft. Note location of
remaining shim washers used between chassis
and mower deck pan arms. Slide shaft from
chassis and mower deck.
4. Remove hair pin cotter and washer from each
deck adjustment rod. Carefully push each link
toward the inside of the mower chassis. At this
point, deck will drop down.
5. Carefully raise and support front of chassis.
Slide mower deck to either side for removal.
(Reverse procedure to reinstall deck assembly.)