Dixon 13631-0702 - Manual (Page 34)

34
CARE AND MAINTENANCE
Deck Removal - Manual Clutch
Models 3303 & 3304
1. Place cut height lever in lowest cut position.
2. Loosen belt keepers.
3. Remove deck drive belt from engine pulley.
4. Using a slight upward twisting motion, remove
link from engagement handle.
5, Turn handle fully to the left until handle clears
stop on mower deck pan. Lift and remove
handle through hole in lower body.
6. Remove hair pin cotter and washer from one
end of deck support cross shaft. Note location
of remaining shim washers used between
chassis and mower deck pan arms. Slide shaft
from chassis and mower deck.
7. Remove hair pin cotter and washer from each
deck adjustment rod. Carefully push each link
toward the inside of the mower chassis. At this
point, deck will drop down.
8. Carefully raise and support front of chassis.
Slide mower deck to either side for removal.
(Reverse procedure to reinstall deck assembly.)