Norsat 25W ATOM - Manual (Page 18)

ATOM 25W/40W/50W Revision 1.1
908239
18 908239_r1.1 - Operator Manual ATOM KU
25-40-50W.doc
Each command response will have the following format:
where msg is as described above and in the commands summary and example tables below. Note that a
response is enveloped by leading and trailing characters.
Table 2-3: Commands Summary
Command Param-Value
Pairs
Response Format
(enveloping characters not shown)
getident None ok pn swver sn
where:
= unit part number label
= software version label
= unit serial number label
getstatus None ok fault fwdpwr revpwr temp
where:
= fault flag, either 0 (no fault) or 1 (fault) .
Use the getfaults command to determine the specific fault(s)
= forward power value, in dBm
= currently not used but reserved for reverse power
= internal system temperature in degrees Celsius
getfaults None ok mute overTemp pll
where:
= 0 (unit unmuted) or 1 (unit muted)
= 0 (temp ok) or 1 (error - over temp condition exists)
= 0 (pll ok) or 1 (error – pll loss of lock)
resetfaults None ok
setmute cmd (0|1)
0 = unmute
1 = mute
ok
M UTE L OGIC
The unit will be muted when any of the following conditions exist:
1. A software mute command is issued through the serial interface.
2. A mute command/signal is issued through the discrete SHUTDOWN line ( Pin D: Shutdown (i.e.
Mute Control) .
3. A fault condition exists.