NewHank BDP-432 - Manual (Page 4)

2
Safety Notice and Importance
Notice
The player complies with the limit regulation on using connection cable within 3m in EMC directive.
Placement
•
Place the player in a location with adequate ventilation to prevent heat build-up in the player.
•
Do not place the player on a soft surface such as a rug that might block the ventilation holes.
•
Do not install the player unit in a confined space, such (e.g. bookshelf or similar place).
•Do not place the player near heat sources, irradiated by sunlight directly, with too much dust or
mechanical impact.
•Do not place the player outdoors, in vehicle, or boat.
•
If the player is brought directly from a cold to a warm location, or is placed in a very damp room,
moisture may condense on the lenses inside the player. Should this occur, the player may not operate
properly. In this case, remove the disc and leave the player turned on for about half an hour until
the moisture evaporates.
•
Do not install the unit in an inclined position. It is designed to be operated in a horizontal position only.
•The player should be installed and operated at least 20cm away from your body (excluding limbs: hands,
wrists, feet and ankles).
•Do not place any heavy or instable objects on the player.
•Do not place any object other than discs on the disc tray, or the player or the object will be damaged.
•
Before you move the player, please take out all discs, or else the discs may be damaged.
•
Before you move the player, disconnect the AC power line and other cables from the player.
Power supply
•As long as the power line of the player is still connected to the wall outlet, the AC power supply of the
player is still connected even if the power supply is turned off.
•If you won’t use the player for a long time, please
disconnect power line from the wall outlet.
•Please hold the plug
and take it gently out of the mains socket. Be advised not to pull the cable.
•
Do not connect the player if the power line is damaged, for you will risk an electric shock or fire.
•Do not clip the AC power line between the player and wall, bookshelf, etc.
•Do not put any heavy object on the AC power line
.
Adjusting volume
When you listen to any material with low input level or no audio signal, do not
suddenly turn up the volume,
You wil risk to damage your hearing and your speakers.
Cleaning
Please wipe the
player with a soft cloth. Do not use any sandpaper, polishing powder
or solution (e.g. alcohol, gasoline).
Cleaning disc, disc/lens cleanser
Do not use cleaning disc or disc/lens cleanser (including wet or spray), or else it may damage the
player.
Notice for replacing parts
If the player is repaired, the parts may be collected for recycle.
Connecting to HDMI OUT port
Improper operation may damage
the HDMI out port and the connection. Please follow the notice below.
•
First check the shape of the port on the HDMI cable, and then align and connect to the HDMI port
on the rear side of the player. Make sure that the connector isn’t upside-down or inclined.
•When you move the player, please
remove the HDMI cable.
•When you connect or
disconnect the HDMI cable, please hold the HDMI connector uprightly. Do not twist or
use force .