Nevion D422-MG - Manual (Page 14)

D422-MG Rev. H
nevion.com | 14
Figure 7:
The command “0319?” was then sent to the card, which responded with
1903D422-MG/1310nm,-7.5dBm
hw rev 1.0
sw rev 2.2.0
fpga rev 5
protocol ver 1.0
The command “remote” is used to enable or disable remote Flashlink control. To disable:
“remote 0”. To enable on port 1 use the command “remote 1”, and so on up to port 8. The
example above shows selecting port 1 for remote control. Below is shown the result, frame 5
was in our example sitting at the remote end of the D422-MG fiber link, and wired up
according to the previous chapter.