Nevion D422-MG - Manual (Page 11)

D422-MG Rev. H
nevion.com | 11
GPI IN connectors
The GPI inputs are internally connected to +5V via a pull-up resistor. The inputs will be
activated when pulling them to Ground.
GPI OUT connectors
The GPI outputs are of open collector type. An output can switch a maximum load of 100mA
at 30V.
Any device to be controlled by the GPI outputs (lamp, LED or similar) needs to be connected
to an external supply voltage on one end and to the GPI output on the other end.
Output Pin
GPI IN1 1
GPI IN2 2
GPI IN3 3
Ground 4
Output Pin
GPI IN4 1
GPI IN5 2
GPI IN6 3
Ground 4
Output Pin
GPI OUT 1 1
GPI OUT 2 2
GPI OUT 3 3
Ground 4
Output Pin
GPI OUT 4 1
GPI OUT 5 2
GPI OUT 6 3
Ground 4