beautypg.com

Figure 22: pps & event latch configuration, Figure 23: event latch output rate – NavCom RT-3020 Rev.F User Manual

Page 78

background image

RT-3020 User Guide – Rev. F

In StarUtil, enable the Event Latch message (0xB4) in
the NCT Binary Messages output list. Select
Receiver > Messages > NCT output from the menu
bar to open the list. Set the Message Rate for 0xB4 to
On Trigger. Right-Click in the Rate cell for message
B4. Select Other > On Trigger from the menu (see
Figure 23). Once configured, the Event Latch
Message (0xB4) is output upon recognition of an
input trigger by the receiver.

‡

Message 0xB4 is described in the
Technical Reference Manual (see Related
Documents
in the fore-matter).

Figure 22: PPS & Event Latch Configuration

The PPS and Event Latch window opens (see
Figure 22).

Figure 23: Event Latch Output Rate

C-76